Scott’s been working pretty steadily the last couple of weeks (thanks to a few relatively quiet days) on the insulation.
He’s using construction adhesive to attach the insulation to the walls. On the walls, this has been working great. He just leans a beam or 2x against the panel to hold it in place while it sets, and they set pretty quickly.
The large pieces went in quickly. It’s all the small spaces left that have to be measured and custom that are a little slower going, but I’m told it’s not too big of a deal.
If we were doing this again, and could know in advance, one could put up studs spaced exactly to fit one panel of insulation between each, eliminating cuts except for around electrical outlets.
A note on the outlets: You may notice they’re close to the floor. 18 inches up is code, but you can have them lower if you install GFCI outlets. (I’m no code expert, check your local regulations, yada yada yada.)
Plans for the next week include: finishing the insulation, cutting a hole for the HVAC unit/installing it, and starting on plumbing installation.
A few more pics. Click for a larger image.
We’re covering the walls with cedar board, which I’m going to whitewash. It’s going to be gorgeous! Here’s a link to what I’m thinking: Whitewashing Plank Walls